SANITEK sanitizer for reverse osmosis water sources for ten uses..

SANITEK sanitizer for reverse osmosis and water dispenser for ten uses.

Bottle with disinfectant to sanitize reverse osmosis, filtration equipment and water dispensers. Able to eliminate bacteria, pathogens and biofilm.

It is appropriate to carry out disinfection every 6 or 12 months depending on the number of people who access the equipment to drink. And at least every time you change the filters.

RO disinfection process:

1.      Close the water faucet at the entrance to the equipment. Empty the water from the tank using the tap.
2.      Remove the cartridges and membrane, keep the post filter.
3.      Pour 50 ml of the Sanitek product into the first cartridge holder.
4.      Screw on the cartridge holders.
5.      Open the inlet valve of the equipment.
6.      Wait 20 minutes for it to take effect.
7.      Empty the tank and let the water run for one minute.
8.      Proceed to change the filters.

Disinfection process for your water dispenser:

1.      Lift the lid on the top dispenser housing to access the water tank and remove the cap covering it.
2.      Pour 50 ml of the Sanitek product into the tank.
3.      Wait 20 minutes for it to take effect without consuming water from the dispenser.
4.      Empty all the water from the water dispenser, usually they have a drain behind them.
5.      Let it fill the water tank again and repeat the process, normally with two emptyings there is enough.

Composition:

• 13.3% Hydrogen Peroxide 3%
• 86.7% Demineralized Water